Hello:
The short of it:
My PBX users are periodically getting the "all circuits are busy" message on my RentPbx / Incredible PBX.
Can you suggest what might be wrong with my setup?
Thanks,
Rob.
The long of it:
I have Anveo Direct setup as per http://nerdvittles.com/?p=5680 so I have these items setup to support it:
Trunks:
AnveoOut (Custom)
Anveo1 (sip)
Anveo2 (sip)
Anveo3 (sip)
Anveo4 (sip)
Anveo5 (sip)
Outbound Routes:
AnveoSip (trunk sequence = AnveoOut)
Inbound Routes:
3 Anveo Direct DID's whose "Destinations" are separate DISA's
I also have voip.ms setup with the following items to support it:
Trunks:
vmsT1 (sip) (Register String: vms_sub-account 1)
vmsT2 (sip) (Register String: vms_sub-account 2)
vmsT3 (sip) (Register String: vms_sub-account 3)
OutBound Routes:
**** None ****
Inbound Routes:
DIDvms1 (Routing: sub-account 1) Destination: DISA_vms1
DIDvms2 (Routing: sub-account 2) Destination: DISA_vms2
DIDvms3 (Routing: sub-account 3) Destination: DISA_vms3
I also have one extension set up for one user who uses his Yealink to place out going calls only. (As a matter of fact, all the uses use the PBX to place out going calls only.)
There are only 2 main users: the Yealink user and one DISA user. The other 5 DISA users use the PBX very infrequently.
Usage of PBX:
Anveo Direct voip.ms Total
Inbound 100 1017 1117
Outbound 1700 0 1700
Total 1800 1017 2817
Anveo Direct informed me that I may have 10 incoming calls *** and *** 10 outgoing calls going on similtaneously.
Do I need to setup 10 Anveo Outbound routes? (Eg: AnveoSip, AnveoSip2, ... AnveoSip10.)
Any help with this would be appreciated.
Rob.
↧