I have a Cisco/Linksys PAP2T which is used for my NextAlarm ABN (Alarm Broadband Network) Security home alarm system using the Visonic Abbra Panel with a ASUS EA-N66R Wireless Bridge that connects to my WiFi network. The Software Version is 5.1.6(LS) and Hardware Version: 0.3.5. I do not have the admin password but here is a question, when I power on the PAP2T, the Power/Internet and Phone 1 has solid green leds. However, it seems the Phone 1 LED turns off while the Power/Internet remains solid green and that is when the alarm panel will complain about trouble - communications failure which will have this beep for the next 10-12 hours when the Abbra panel decides to communicate again with NextAlarm except that is only possible when I unplug the power and replug it back in to get the Phone 1 with a green led along with the Power/Internet already having a green led. My question is, is there anyway for the PAP2T to get the Phone 1 green led solid on it's own after it goes off by retrying to register again since unless I am at home, I have no way to reboot the PAP2T which means if I am away and the Phone 1 LED went off and the alarm system is armed and someone tripped it, it would not be possible to have the alarm system call the alarm monitoring center for help.
↧