Hello:
I setup a FreePbx pbx on a RentPbx server and then added an Anveo trunk, an outbound route using the Anveo trunk, an inbound route using the Anveo DID which is directed to the only extension (702) that has been created.
I hooked a Yealink T23G ip phone to my router and setup account # 1 with the extension 702 credentials.
I can make outgoing calls from the T23G but I cannot call it. When I dial the DID (set up as the inbound route) I get one ring and then it switches to a busy signal.
Does anyone know why I can't call in?
Thanks,
Rob
Partial info of ext 702:
dtmfmode rfc2833canreinvite nocontext from-internalhost dynamictype friendnat yesport 5060qualify yescallgrouppickupgroup disallowallow dial SIP/702accountcode mailbox 702@devicedeny 0.0.0.0/0.0.0.0permit 0.0.0.0/0.0.0.0
↧